Garage Sale @ SuperNova19.com
Serious inquiries only with serious offers. All will be considered.
Mark@SuperNova19.com
I've bought so many parts over the years they're piling up.
There is no reason that I need three intakes for the same motor. Or look for something for a year, spend more then you should for it and then use it for 5 minutes checking something and then put it on a shelf never to be touched again. The peace of mind was worth it but why keep it?
Now you see why it's time to unload and make some space. You can also help with the Race boat's restoration by helping to make some space and me a couple bucks so I can buy more parts. If you need it you're not going to find it cheaper so hit us with an email.
Most everything will come with the weight in the description so you can figure shipping.
So let's get to the shopping.
Boat Parts
MerCruiser 7.4 Cowl
These are in excellent shape. I have two of them that would not work in a 1969 raceboat but they may work good in yours. They sure do look good.
Volvo Tilt Control
Lots of good stuff in this box. It’s the black box that sits on the top of the tilt drive with all good circuits inside. Full control harness with factory ends and a couple of motors. One spins freely, one is rough. Condition is unknown.
Volvo Drive Shield Parts
Water pick up tube, Steering bar and universal linkage. All good to go.
454 Throttle Linkage Bracket
Off of a MIE340 Mercruiser. Good as the day it was made.
Volvo Penta Yoke
The old style Volvo Penta drive shaft yoke. Not a thing wrong with it. Had to go to a fine spline to match a bellhousing so it is just left over.
3 1/4 Inch Gauge Holder
For the dash of your boat or the hood of your car. If you need a place to mount a 4” gauge this is it. A quick sanding and paint job to match what ever you mount it to and you will be all set.
Blue Vector Speedometer
Blue Vector Series - The Vector Series has crisp blue and white graphics on a deep charcoal background, with black bezel speedometer has a 3 5/16" diameter dials and require a 3 13/32" cutout. Ready to go.
14" Steering Wheel
Stainless Steel Destroyer Steering Wheel Made of non-magnetic type 304 stainless steel 13-1/2" diameter, 5 spokes with wood center cap, Wheel has 22º of dish, Fits standard 3/4" tapered shaft helm.
30+ years old and looks as good as new.
Volvo 280 Transom Shield
A little cleaning and paint and it's ready to go in.
Velvet Drives
Twin Velvet drives off of a set of 454's. They are 1.52 to 1 and will not work for the race boat.
My loss is your gain. Make an offer.
MerCruser 888 Outdrive
MerCruser 888. I bought it for my 19’ Larson that originally came with a Ford 302. It came from a big reputable marine shop in the area. It was advertised “ready to go”. When I got to the shop on a Saturday only the owner was there to meet me. I had it on my truck and was BS’ing with the guy ready to leave when I went to put it gear explaining something and it would not lock. The owner was so embarrassed (I figured someone got fired on Monday) that he opened his shop back up and preceded to rebuild it right in front of me. Around the same time I replaced the 302 with a 351winsor and it worked great with both motors. I only got to use it for one season before I hit submerged object (only the front half of the boat took damage). The boats hull was not worth fixing. The motor is now in a tow truck and I kept the drive but not having a use for it its time to let it go. I am only getting about ½ of what I paid for everything I seem to be selling off lately so I will take $750.00 for it.
This is a pick up thing.
Big Block Chevy Marine Stuff
Mercuriser 496 Risers
Not your standard riser by a long shot.
Some paint rash but beside that they are perfect. Bought them by mistake for my 454 exhaust and they don't fit so they have to go. Will consider trade for risers I need.
BBC Head Stud Girdles
Stud girdles will strengthen the weak link in the valve train. While under a tremendous amount of load, the flexing of the studs may cause loss of horsepower or engine failure. Stud girdles require less adjustment of valve lash and provide enhanced rigidity and strength. Requires the use of tall valve covers.
Bought these for the 454 last winter and didn't install them for some reason. Until I do they are ready to go and up for sale.
9lbs with box
BBC HASTINGS CHROME MOLY PISTON RING SETS
Refreshed Chevy Heads
Big Block Chevy Heads, "peanut" round ports 14092360, removed from a 1986 Mercruiser MIE340, complete and in good shape.
These came on a motor I bought that I am only using the block. They were rebuilt, test fired the motor and then sat for a year or so.
MerCruiser Dipstick Tube Assembly
454/502 BBC GM 8qt oil pan tube and aftermarket dipstick.
I bought this because my MIE 340 motor didn't come with the original and was not sure I had the proper oil level with the aftermarket stick I used.
Spent about a year looking for one. Bought it, checked against what I had (it was right). Kept the original stick in my motor (I like original) and put the after market in the extra tube and put it on a shelf.
It's time for it to find a new home.
Mercruiser BBC Valve Covers
I have 2 sets of these for a BBC. That’s 2 sets more then I need so they have to go.
Rochester 4M (Quadrajet) marine application carburetor
MCM/MIE 228, 230, 260, 330, 340 w/305", 350", 454"
This is professionally remanufactured to original specifications-good as new for less money!
Thunderbolt IV & V and Ignition Module For GM V-8
Not sure of the condition. I have never run this distributor. It came with a motor I am building for a boat and new ignition system is in the works for it. So I have no use for this one. The cap is broken (I did that moving the motor) but beside that it all looks good to go.
Some Misc Auto 454 Parts
(had to get all these motors from somewhere)
1103952 - Distributor Assembly
This complete distributor is used on late model V8 engines with fuel injection and computer controls. This also comes with the coil that is attached. I have never used this coil and dist. It came with a motor I am building for a boat and this is for a auto so I have no use for it. Everything else seems fine but again I have never used it so I don't know. It has to be an “as is item” but again it will be cheap because I don't know.
Stock Gen V 454 Oil Pan
This is another "take off" of a motor I am building for a boat. I have a 8qt pan for the motor so again I have no use for this except to take up space in the garage.
It's a little dirty but there is nothing wrong with it.
Waterpump, Pulley and Crank Pulley
All off of a Gen V 454.
It's a long pump compared to a Mercruiser so it wont work for me but it could for you.
Props
These are all for Volvo Penta outdrives.
(Remember that all Volvo Pentas are reversible)
Each prop weighs 6 to 10 lbs each w/o box
Aluminum 14X23 Left (short shaft)
When I bought this prop it was on a Donzi. It has some normal use on it but is in good shape overall.
Aluminum 16X23 Left (short shaft)
This prop is near perfect except for some paint.
I also don't think you will find another like it. It's the only Volvo prop I have found in this size that's for sure.
Aluminum 14X23 Right (short shaft)
This prop has seen better days but it is sound and would make a good back-up prop
Aluminum 14X16 Left (short shaft)
Another prop that I'm not sure how it became mine.
It is in pretty good shape but does have some minor use on it.
14X23 Ellison racing props. (2) right's and (1) Left (short shaft)
*********Update*******
There is only one right hand prop left.
These are a rare find and to have 4 of them is just unheard of.
What we have here is 3 Ellison offshore props. These props would retail for over $700 each and that was many years ago. They have never been touched or reworked in any way. Run them like they are or do what I did below for $100 and have the nicest prop you could ever have on a Volvo. Sadly they all have to go due to not having enough pitch for what I built.
16X26 Left, Ellison racing prop (short shaft)
Almost perfect.
Besides a polishing to make it shinny this prop is ready to go.
15X19 Cupped, Right, Johnson prop (short shaft)
Another great Bronze, Volvo prop.
This prop is in great shape with only some light use. Bolt up and it's ready to go.
14lb w/o box
Serious inquiries only with serious offers. All will be considered.
Mark@SuperNova19.com
The SuperNova19 Network
